Accessory
Voltage-pulse converter
AC-IP-K If there is an input of 230V at the converter, the output will be one pulse per second.

Art.Nr.01/AC/IP-KONVERTER

Read more... [Voltage-pulse converter]
 
AC/DC Konverter
AC-DC-K AC / DC converter for recording an external 230VAC - signal from UVR-controllers. If there is an input of 230VAC, the controller will display ON. IF there is no input, it displays OFF.

Art.Nr.01/AC/DC-KONVERTER

Read more... [AC/DC Konverter]
 
DL-BC
DL-BC

The DL-BC is able to read data from the DL of one controller and put it on the data-line of a second controller. The transmission of data is available in both directions. Is also possible to connect two temperature sensores (KTY or Pt1000) and put theese data to both controller over the DL.

Art.Nr.01/DL-BC

 

Read more... [DL-BC]
 
Rollfeder zur Fühlermontage
There are no translations available.

Rollfeder

Die einfache Montage des Sensors und ein ausgezeichneter

Wärmeübergang sprechen sehr für diese Montageform. Ein

wesentlicher Vorteil ergibt sich durch den großen Einsatzbereich

(15–45 mm Rohrdurchmesser) und dem geringen Auftrag am

Rohrdurchmesser, wonach die Rohrisolation noch leicht möglich

ist.

 

Art. Nr.: 01/RF

Read more... [Rollfeder zur Fühlermontage]
 
Jumbo display

display

Three digits, figure size 25.4 mm to enable setup of giant displays. Can be joined together to produce six figures. The desired information (temperatures, output statuses, heat quantity, speed, etc.) is selected from the controller data line via a jumper.

 

Art. no.: 01/DISPLAY

Read more... [Jumbo display]
 
Control printed circuit board for jumbo display

DISPLAY-VSM

It is connected to the data line between the controller and jumbo displays and adds information regarding the brightness of the surrounding area to the data stream to regulate contrast. The rotary switch allows data to be pre-selected for corresponding pre-coded jumbo displays. It is only suitable for the controler UVR1611, UVR61-3, UVR61-PV and UVR63-H.

 

Art. no.: 01/DISPLAY-VSM

Read more... [Control printed circuit board for jumbo display]
 
Plug-in adaptor for jumbo display

NETZTEIL

 

This 7.5-volt adaptor is required to supply power to the control printed circuit board and up to 6 jumbo displays.

 

Art. Nr.: 01/NETZTEIL

 
Immersion sleeves
TH_

Brass, precision manufactured to ensure good heat transmission to the sensor, 6 mm internal diameter, 1/2’’ male thread, wrench size 22, PG7 female thread for supplied strain relief, lengths 40-300 mm.

Art. no.: 01/TH40
Art. no.: 01/TH60
Art. no.: 01/TH90
Art. no.: 01/TH140
Art. no.: 01/TH200
Art. no.: 01/TH300

Non-rusting material: like brass immersion sleeve, 140 mm long

Art. no.: 01/TH140Niro
Art. no.: 01/TH60Niro

 

 
DC pump Ecocirc
D5SOLAR-38_700B DC pump for PV-powered solar thermal with a max. 8m².

Art. Nr.: 01/D5-SOLAR-38/700B
Read more... [DC pump Ecocirc]
 
RC-Glied
There are no translations available.

RC-Glied

Triaclast zum sicheren Schalten von Triacausgängen in Verbindung mit kleinen Lasten (Ventile, Relais,..)

 

Art.Nr.01/RC-GLIED


 
Netzfilter
There are no translations available.

NM-FILTER Netzfilter, der bei Nutzung der Drezahlregelung im Modus Phasenanschnittsteuerung gesetzlich vorgeschrieben ist.

Art.Nr.01/NM-FILTER
 
Sensor extension cable

XYZWL

The sensor cables can be extended up to 50 m with a cable cross-section of 0.50 mm². Available in coils of 100 m and 250 m.

 

Art. no.: 01/XYZWL100

Art. no.: 01/XYZWL250

 

valid XHTMLXHTML and CSSCSS.